[Assassins]

(Видео-уроки по Link Layer) CCIE:R&S Self-Paced Lesson Link Layer

Производитель: netmasterclass
Год выпуска: 2009
Язык: английский

Описание: This self-paced Lesson Module provides a set of three complementary learning resources:
Seven hours of video on demand instruction on Link-Layer Technologies
Supplementary "Spot-the-Issues" soft assessment quizzes
Two hands-on labs focused on the subject of configuring Link-Layer Technologies.

The absolute centerpiece of this Lesson Module is the Link-Layer video on demand instruction. The following split screen format of each Video on Demand module provides the powerful learning experience of looking over a CCIE's shoulder while he both configures and explains the operation of Link Layer technologies

Видео кодек: Flash

The VoD�s in this Lesson Module cover the following topics

BLOCK-0: Interface Classification and Configuring Point-to-Point Links (5 VoD's)
Performing a General Classificaiton of Interfaces
Addressing Point-to-Point Interface Configuration Issues
Conguring a GRE Tunnel Interface
Configuring an IPIP Tunnel Interface
Addressing Recursive Routing Issues with Logical Tunnels

BLOCK-1: Comparing the Catalyst Layer 2 versus Layer 3 Port Configuration Options (2 VoD's)
Comparing Configuration Issues Between Routed and Switched Ports Part-1
Comparing Configuration Issues Between Routed and Switched Ports Part-2

BLOCK-2: Configuring Access Ports on a Catalyst Switch (4 VoD�s)
Configuring Access Ports on a Catalyst Switch Part-1
Configuring Access Ports on a Catalyst Switch Part-2
Configuring Access Ports on a Catalyst Switch Part-3
Configuring Access Ports on a Catalyst Switch Part-4

BLOCK-3: Configuring Catalyst Port Speeds, Duplex Settings and UDLD (2 VoD's)
Reviewing Port Speed and Duplex Setting Options
Reviewing the UDLD Configuration Options

BLOCK-4: Configuring VTP (4 VoD's)
Introduction to VTP
Review of Different VTP Modes
Configuring VTP Part-1
Configuring VTP Part-2
VTP Pruning

BLOCK-5: Configuring Trunk Ports (5 VoD's)
Using DTP to Dynamically Configure Trunk Ports Part-1
Using DTP to Dynamically Configure Trunk Ports Part-2
Statically Configuring Catalyst Trunk Ports Part-1
Statically Configuring Catalyst Trunk Ports Part-2
DTP Negotiation

BLOCK-6: Configuring 802.1Q and the Native VLAN (2 VoD's)
Statically Configuring Catalyst Trunk Ports Part-1
Statically Configuring Catalyst Trunk Ports Part-1

BLOCK-7: Configuring EtherChannel (4 VoD's)
Configuring EtherChannel Part-1
Configuring EtherChannel Part-2
Configuring EtherChannel Part-3
Configuring EtherChannel Part-4

BLOCK-8: Configuring Spanning Tree (5 VoD's)
Configuring Spanning Tree Part-1
Configuring Spanning Tree Part-2
Configuring Spanning Tree Part-3
Configuring MST
Configuring RSTP